Important: openssl security update (Amazon Linux 2023)

Package updates are available for Amazon Linux 2023 that fix the following vulnerabilities: CVE-2026-84784: Issue summary: A malicious remote peer may flood the local QUIC stack with NEW_CONNECTION_ID frames by avoiding a limit check on how many connection IDs the remote QUIC stack can use. Impact summary: The local QUIC stack sends a RETIRE_CONN_ID frame for every NEW_CONNECTION_ID frame it receives. The RETIRE_CONN_ID frame is dispatched via the Control Frame Queue (CFQ). If the remote peer also withholds ACKs, then it can force the local stack to allocate ~400MB (depending on ACK delay). CWE: CWE-770: Allocation of Resources Without Limits or Throttling Description: RFC 9000 sections 5.1.1 and 5.1.2 [1] describe the mechanism by which a remote peer can notify the local QUIC stack to change the destination connection ID (a.k.a. CID) the local stack uses to identify the connection at the remote peer. Each CID is associated with a sequence number. The sequence number is transmitted in NEW_CONNECTION_ID and RETIRE_CONNECTION_ID frames to identify the CID which is being either associated with a connection or retired. The remote peer sends a NEW_CONNECTION_ID frame to let the local stack know a new CID is being associated with an existing connection. The NEW_CONNECTION_ID frame carries the new CID, its sequence number, and the retire-prior-to number. The retire-prior-to identifies existing CIDs that are to be retired. The local QUIC stack must send a RETIRE_CONNECTION_ID for every destination CID whose sequence number is less than retire-prior-to. The CID becomes retired after the local stack receives an ACK for its RETIRE_CONNECTION_ID frame. Although the OpenSSL QUIC stack supports at most one destination CID for every connection, it can be tricked into processing more than one RETIRE_CONNECTION_ID frame per connection. The OpenSSL QUIC stack currently retires the destination CID as soon as it receives the NEW_CONNECTION_ID, while in fact the destination CID must be retired after an ACK for the RETIRE_CONNECTION_ID frame is received. Correcting the flawed logic also fixes the backlog growth. [1] https://datatracker.ietf.org/doc/html/rfc9000#name-issuing-connection-ids FIPS impact: no The FIPS module is not affected as the QUIC implementation is outside of the OpenSSL FIPS module boundary. CVE-2026-84782: A flaw was found in OpenSSL. The Datagram Transport Layer Security (DTLS) retransmission mechanism fails to properly handle handshake message writes that are suspended before completion. A remote attacker could exploit this vulnerability during handshake message retransmission, causing OpenSSL to read past the message buffer or overwrite internal state required to resume writing. This issue can result in information disclosure through out-of-bounds memory reads or cause a Denial of Service (DoS) by crashing the process. CVE-2026-75806: Issue summary: An established DTLS 1.2 association using an AEAD cipher suite can be terminated by a single unauthenticated datagram whose encrypted fragment is shorter than the mandatory explicit IV and authentication tag overhead. Impact summary: An attacker who can send a datagram that is routed to an existing DTLS 1.2 association can tear that association down without knowing any key material. This is a Denial of Service limited to the targeted association. There is no memory safety or confidentiality impact. CWE: CWE-1284: Improper Validation of Specified Quantity in Input Description: In TLS 1.2 and DTLS 1.2 every record protected by an AEAD cipher suite carries an explicit IV followed by the ciphertext and an authentication tag. When decrypting such a record the record layer passed the record length to the cipher implementation before checking that the record was long enough to contain the explicit IV and the tag. For a record shorter than that overhead the cipher implementation rejected the impossible length, and the record layer treated this as an internal failure and raised a fatal internal_error alert instead of treating the record as one that failed authentication. In TLS 1.2 the same record causes a fatal internal_error alert instead of the expected bad_record_mac alert. Since any undecryptable record already terminates a TLS connection, this is a protocol conformance issue rather than a security issue in TLS. The fix validates the record length against the explicit IV and tag length before any AEAD processing, so that TLS reports bad_record_mac and DTLS silently discards the record. FIPS impact: no The affected code is outside the FIPS module boundary. CVE-2026-75805: Issue summary: A CMP client that requests certificate revocation on the basis of a PKCS#10 CSR may dereference a NULL pointer and terminate abnormally when processing a crafted revocation response. Impact summary: The NULL pointer dereference happens on a read which leads to a crash and a Denial of Service for the affected client application. CWE: CWE-476: NULL-pointer dereference Description: A CMP client revoking a certificate has to tell the server which certificate to revoke, and may do so by supplying a PKCS#10 CSR instead of the certificate itself or its issuer name and serial number. This is 'openssl cmp -cmd rr -csr <file>' on the command line, or OSSL_CMP_exec_RR_ses() with the certificate supplied via OSSL_CMP_CTX_set1_p10CSR() through the API. A CSR does not contain the issuer name and serial number of the certificate, so the client does not send them. A server may optionally name the certificate it revoked in its response, and the client then compares that name against what it sent. Having sent neither an issuer name nor a serial number, it has nothing to compare against, and a server returning a specially crafted name causes the client to read from a NULL pointer and crash. The revocation response is checked for valid message protection before the affected code is reached, so an attacker must be a malicious or compromised CMP server, or a man-in-the-middle in possess