Important: edk2 security update (Amazon Linux 2023)

Package updates are available for Amazon Linux 2023 that fix the following vulnerabilities: CVE-2026-84782: A flaw was found in OpenSSL. The Datagram Transport Layer Security (DTLS) retransmission mechanism fails to properly handle handshake message writes that are suspended before completion. A remote attacker could exploit this vulnerability during handshake message retransmission, causing OpenSSL to read past the message buffer or overwrite internal state required to resume writing. This issue can result in information disclosure through out-of-bounds memory reads or cause a Denial of Service (DoS) by crashing the process. CVE-2026-75806: Issue summary: An established DTLS 1.2 association using an AEAD cipher suite can be terminated by a single unauthenticated datagram whose encrypted fragment is shorter than the mandatory explicit IV and authentication tag overhead. Impact summary: An attacker who can send a datagram that is routed to an existing DTLS 1.2 association can tear that association down without knowing any key material. This is a Denial of Service limited to the targeted association. There is no memory safety or confidentiality impact. CWE: CWE-1284: Improper Validation of Specified Quantity in Input Description: In TLS 1.2 and DTLS 1.2 every record protected by an AEAD cipher suite carries an explicit IV followed by the ciphertext and an authentication tag. When decrypting such a record the record layer passed the record length to the cipher implementation before checking that the record was long enough to contain the explicit IV and the tag. For a record shorter than that overhead the cipher implementation rejected the impossible length, and the record layer treated this as an internal failure and raised a fatal internal_error alert instead of treating the record as one that failed authentication. In TLS 1.2 the same record causes a fatal internal_error alert instead of the expected bad_record_mac alert. Since any undecryptable record already terminates a TLS connection, this is a protocol conformance issue rather than a security issue in TLS. The fix validates the record length against the explicit IV and tag length before any AEAD processing, so that TLS reports bad_record_mac and DTLS silently discards the record. FIPS impact: no The affected code is outside the FIPS module boundary. CVE-2026-72897: Issue summary: A TLS server that calls SSL_set_SSL_CTX() to switch a connection to a different SSL_CTX part way through a handshake may access memory beyond the end of an internal array if the replacement context knows about more provider signature algorithms than the context the connection was created from. Applications which never call SSL_set_SSL_CTX() are not affected. Impact summary: A remote peer may be able to cause a small out-of-bounds read, and in some circumstances a fixed-value out-of-bounds write, on the server heap. This may lead to a Denial of Service. CWE: CWE-787: Out-of-bounds Write Description: A TLS connection records how many certificate slots it has when it is created, taken from the SSL_CTX that created it: the built-in certificate types plus one slot for each provider TLS-SIGALG entry that context was aware of. That count sizes an internal array of per-slot certificate validity flags. An application may replace a connection's SSL_CTX part way through the handshake by calling SSL_set_SSL_CTX(), most commonly from a servername callback in order to serve a different virtual host. Doing so did not refresh the recorded count. A provider signature algorithm's slot index is its position in the list of whichever context resolves it, so if the replacement context is aware of more of them than the original, an algorithm offered by the peer can resolve to an index beyond the end of the array. Processing the peer's signature algorithms then reads one four byte word past the end for each such algorithm and, where the word read is zero, writes a fixed value over it. A peer offering many of them can corrupt heap metadata and abort the process. Only provider signature algorithms which occupy one of the excess slots, and which the server also has configured, have this effect. Codepoints the replacement context does not recognise are discarded without being resolved to a slot, and provider signature algorithms are usable only from TLS 1.3. The two contexts must therefore be aware of different numbers of provider signature algorithms, which requires separate library contexts, a provider loaded between the two being created, or providers which differ in what they advertise - in 4.0, for example, the default provider advertises SM2 where the FIPS provider does not. A deployment meeting the condition is also unable to negotiate the affected algorithms with legitimate clients, since the same stale count hides the corresponding certificates, so the misconfiguration is likely to be noticed. For that reason, and because the configuration is not the default, this issue has been assessed as Low severity. FIPS impact: no No FIPS modules are affected by this issue as the affected code is outside the OpenSSL FIPS module boundary. CVE-2026-54872: Issue summary: The generic elliptic-curve scalar multiplication used for ECDSA and SM2 signature operations with curves that do not have a dedicated implementation leaks information about the secret nonce through timing. Impact summary: An attacker able to measure signing times may learn information about the per-signature secret nonce, which over many signatures can, via a lattice / Hidden Number Problem attack, lead to recovery of the private key. CWE: CWE-208: Observable Timing Discrepancy Description: The generic elliptic-curve scalar multiplication used for curves that do not have a dedicated constant-time implementation pads the secret scalar with non-constant-time BIGNUM operations, so the time taken depends on the value of the secret scalar derived from the ECDSA and SM2 nonce. The leak is very small; observing it requires a large