Vendor
Omron
61 known vulnerabilities.
Products
CX-Programmer 19
CX-Position 7
CX-Supervisor 4
CX-One 4
Machine Automation Controller NJ-series 3
Machine Automation Controller NX-series 3
Machine automation controller NJ series, Machine automation controller NX series, Automation software 'Sysmac Studio', and Programmable Terminal (PT) NA series 3
CX-Protocol 3
CX-Server 3
CJ-series and CS-series CPU modules 2
Sysmac Studio 2
NS15 2
NS12 2
NS10 2
NS8 2
NS5 2
CX-Motion Pro 1
CJ1M SYSMAC CJ-series 1
CJ1M SYSMAC CS-series 1
CX-Protocol within CX-One 1
CJ1M SYSMAC CP-series 1
CX-Designer 1
CX-Motion-MCH 1
CX-One CX-One CXONE-AL[][]D-V4 1
Sysmac Studio SYSMAC-SE2[][][] 1
OMRON CX-Supervisor 1
Multiple OMRON products which implement FINS protocol 1
CX-Programmer within CX-One 1
CX-Drive All models 1
Sysmac Studio Software 1
FA Integrated Tool Package CX-One 1
CJ2M CPU Unit 1
CJ2H CPU Unit 1
CS/CJ Series EtherNet/IP Unit 1
CX-Drive 1
SYSMAC-SE2[][][] 1
NJ Series CPU Unit 1
NX Series CPU Unit 1
Programable Terminals NB-Designer 1
Omron PLC CJ Series 1
4 results · Clear filters · Feed
-
Critical 9.8
FINS (Factory Interface Network Service) is a message communication protocol, which is designed to be used in closed FA…
-
Critical 9.1
Omron CJ1M unit v4.0 and prior has improper access controls on the memory region where the UM password is stored. If an…
-
Critical 9.8
Active debug code exists in OMRON CP1L-EL20DR-D all versions, which may lead to a command that is not specified in FINS…
-
Critical 9.4
Use of hard-coded credentials vulnerability exists in Machine automation controller NJ series all models V 1.48 and ear…