dmaengine: idxd: Let probe fail when workqueue cannot be enabled

In the Linux kernel, the following vulnerability has been resolved:

dmaengine: idxd: Let probe fail when workqueue cannot be enabled

The workqueue is enabled when the appropriate driver is loaded and
disabled when the driver is removed. When the driver is removed it
assumes that the workqueue was enabled successfully and proceeds to
free allocations made during workqueue enabling.

Failure during workqueue enabling does not prevent the driver from
being loaded. This is because the error path within drv_enable_wq()
returns success unless a second failure is encountered
during the error path. By returning success it is possible to load
the driver even if the workqueue cannot be enabled and
allocations that do not exist are attempted to be freed during
driver remove.

Some examples of problematic flows:
(a)

idxd_dmaengine_drv_probe() -> drv_enable_wq() -> idxd_wq_request_irq():
In above flow, if idxd_wq_request_irq() fails then
idxd_wq_unmap_portal() is called on error exit path, but
drv_enable_wq() returns 0 because idxd_wq_disable() succeeds. The
driver is thus loaded successfully.

idxd_dmaengine_drv_remove()->drv_disable_wq()->idxd_wq_unmap_portal()
Above flow on driver unload triggers the WARN in devm_iounmap() because
the device resource has already been removed during error path of
drv_enable_wq().

(b)

idxd_dmaengine_drv_probe() -> drv_enable_wq() -> idxd_wq_request_irq():
In above flow, if idxd_wq_request_irq() fails then
idxd_wq_init_percpu_ref() is never called to initialize the percpu
counter, yet the driver loads successfully because drv_enable_wq()
returns 0.

idxd_dmaengine_drv_remove()->__idxd_wq_quiesce()->percpu_ref_kill():
Above flow on driver unload triggers a BUG when attempting to drop the
initial ref of the uninitialized percpu ref:
BUG: kernel NULL pointer dereference, address: 0000000000000010

Fix the drv_enable_wq() error path by returning the original error that
indicates failure of workqueue enabling. This ensures that the probe
fails when an error is encountered and the driver remove paths are only
attempted when the workqueue was enabled successfully.