irqchip/gic-v5: Immediately exec priority drop following activate

In the Linux kernel, the following vulnerability has been resolved:

irqchip/gic-v5: Immediately exec priority drop following activate

With GICv5 an interrupt of equal or lower priority cannot be signalled
until there has been a priority drop. This is done via the GIC CDEOI
system instruction. Once this has been executed, the hardware is able
to signal the next interrupt if there is one.

As all interrupts are programmed to have the same priority, no new
interrupts can be signalled until the priority drop has happened. This
can cause issues when, for example, an interrupt remains active while
a long running process takes place, such as when injecting a physical
interrupt into a guest VM in software.

The GICv5 driver has so far done the priority drop as part of
irq_eoi(), i.e., at the same time as deactivating the interrupt. This
means that any long running process (or VM) could block incoming
interrupts, effectively causing a denial of service for all other
interrupts.

Rather than doing the EOI as part of irq_eoi() (which the name would
suggest would be a good place for it), move it to happen immediately
after acknowledging an interrupt in the main GICv5 interrupt
handler. The deactivation of interrupts (GIC CDDI) remains implemented
as part of irq_eoi(), which means that the same interrupt cannot be
signalled a second time until deactivated by software.