Drivers: hv: Don't reset VMBus connection state on error/exit paths

In the Linux kernel, the following vulnerability has been resolved:

Drivers: hv: Don't reset VMBus connection state on error/exit paths

In two places, current code forces vmbus_connection.conn_state to
DISCONNECTED prior to calling vmbus_disconnect(). But vmbus_disconnect()
calls vmbus_initiate_unload(), which unloads the VMBus connection
only if the conn_state is CONNECTED. Consequently, the connection
remains and the Hyper-V host might continue to send messages or post
VMBus interrupts.

The problem was introduced in commit 74347a99e73ae ("x86/Hyper-V:
Unload vmbus channel in hv panic callback"), in that
vmbus_initiate_unload() started checking the current connection
state before doing the unload. This commit removed some occurrences
where conn_state was forced to DISCONNECTED, but these two remained,
apparently due to an oversight at the time.

Fix this by not forcing conn_state to DISCONNECTED during VMBus exit,
or if a failure occurs when establishing the connection in the first
place. Whatever value conn_state has at the time is then read by
vmbus_initiate_unload() to determine if there is a connection to
be unloaded.